2N Helios IP Base Installation Manual page 39

Configuration:
Connect the 2N
output; refer to the
at least on the
Press and hold the
put the device in the programming mode (both the red and green LEDs are
blinking).
Activate the intercom switch using the keypad, telephone, etc. The first code
sent from the intercom will be stored in the memory and considered valid. After
code initialisation, the
mode (the green LED is blinking).
Caution
In case of resetting the factory default settings on a device with a
version of firmware 2.18 or higher it is necessary to reprogram the 2N
Helios IP Security Relay
Tip
FAQ: 2N
Helios IP intercom?
Tip
Video Tutorial: Door intercoms 2N
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Helios IP Security Relay
2N Helios IP Configuration Manual
®
2N Helios IP Security Relay
®
2N Helios IP Security Relay
®
2N Helios IP Security Relay
using the instructions above.
®
Helios IP Security Relay – what it is and how to use it with 2N
to the properly set intercom switch
. Make sure that one LED
is on or blinking.
Reset button for 5 seconds to
will pass into the operational
®
Helios IP – Security Relay
®
39/60