2N Helios IP Base Installation Manual page 31

Door entry ip intercom
Hide thumbs Also See for Helios IP Base:
Table of Contents

Advertisement

Wait until the red LED goes off (approx. 5 s).
Release the RESET button.
The following network parameters will be set after restart:
IP address: 192.168.1.100
Network mask: 255.255.255.0
Default gateway: 192.168.1.1
Follow the instructions below to switch on the
Press the RESET button.
Wait until the red and green LEDs on the device come on simultaneously
(approx. 20 s).
Wait until the red LED goes off (approx. 5 s).
Wait until the green LED goes off and the red LED comes on again (another 5 s).
Release the RESET button.
Follow the instructions below to
Press the RESET button.
Wait until the red and green LEDs on the device come on simultaneously
(approx. 20 s).
Wait until the red LED goes off (approx. 5 s).
Wait until the green LED goes off and the red LED comes on again (approx. 5 s).
Wait until the red LED goes off (another 5 s).
Release the RESET button.
2N TELEKOMUNIKACE a.s., www.2n.cz
Dynamic IP address
reset the factory default values
mode (DCHP ON):
:
31/60

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Helios IP Base and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Table of Contents