Ip Address Retrieval - 2N Helios IP Base Installation Manual

3.1 Configuration
Configuration takes place typically via a Web interface. Alternatively, it is possible to
configure using the software
via the web interface can be accessed as follows:
Launch your internet browser (Internet Explorer, Firefox, etc.).
Enter the IP address of your intercom (
Log in using the username
You have to know your intercom IP address to log in to the integrated web server.
Upon purchase, 2N
retrieves the IP address automatically if there is a properly configured DHCP server in
the LAN. If no DHCP is available, operate
mode (in default state adress http://192.168.1.100).
If you do not know the IP address of the device it is also possible to use the
®
2N Helios IP Network Scanner,
®
2N IndoorTouch in your network. You can find in section
If your device remains inaccessible (you have forgotten the IP address, the network
configuration has changed, etc.), you can change the network configuration using the
device buttons.
Refer to the Configuration Manual

IP Address Retrieval

Take the following steps to retrieve the
Connect (or, if connected, disconnect and reconnect)
power supply.
Wait for the second sound signal
Press the quick dial button on the main unit 5 times.
®
2N Helios IP Base
If the address is 0.0.0.0, it means that the intercom has not obtained the IP
address from the DHCP server
2N TELEKOMUNIKACE a.s., www.2n.cz
®
2N Access Commander
Admin
®
Helios IP Base is set to the dynamic IP address mode – it
which can find the
for the
will read its IP address.
or service
http://192.168.1.100/
and password 2n .
®
2N Helios IP Base
2N Helios 2N
3.6 Downloads
®
2N Helios IP Base
®
2N Helios IP Base
.
My2N . Configuration
, e.g.).
in the static IP address
®
, Access Unit
.
configuration details.
IP address:
®
2N Helios IP Base
and
to the
43/60