8
03.04
8.3
Output data
8.3.1 Output Data to NC Card working window
Siemens AG, 2004. All rights reserved.
SINUMERIK 840D/840Di/810D Operator's Guide Handheld Terminal 6 (BAH) - 03.04 Edition
Function
The data output runs analogously to the reading in process. However,
it is not meaningful to save in a temporary storage location (i.e.
clipboard), so this is omitted.
Precondition
The Data out softkey has been pressed in the Read in Data working
window.
The same working window opens up as for Read in Data.
Operating sequence
Further buttons
→ Read in Data working window
Data in
→ Output Data to NC Card working window
NC card
Function
Data can also be output to an NC card analogously to the section
"Read in data from NC card".
Precondition
• The NC softkey has been pressed in the Output data working
window.
The following working window is then displayed:
Output Data to NC Card working window
Data Transmission – Operating Area Services
8.3 Output data
Same as Read in Data working window.
8
8-101