Siemens SINUMERIK 840D Operator's Manual page 79

7
03.04
Teach-In
7.1 Introduction................................................................................................................ 7-80
7.2 Block selection .......................................................................................................... 7-81
7.3 Inserting a block ........................................................................................................ 7-82
7.3.1 Inserting a block - circular motion ............................................................................ 7-85
7.3.2 Inserting a block - A-Spline (option).......................................................................... 7-86
7.3.3 Specifying parameters .............................................................................................. 7-86
7.4 Changing a block ...................................................................................................... 7-87
7.5 Replacing a block...................................................................................................... 7-88
7.6 Correction mode........................................................................................................ 7-89
7.7 Example: Creating a new program with teaching ..................................................... 7-89
 Siemens AG, 2004. All rights reserved.
SINUMERIK 840D/840Di/810D Operator's Guide Handheld Terminal 6 (BAH) - 03.04 Edition
7
Teach-In
7-79