Table of Contents
Advertisement
System Telephones on the OpenCom 100 / Aastra 800
2
3
To mount your telephone to the wall, drill two holes at the following distance apart:
OpenPhone 61
OpenPhone 63
OpenPhone 65
Insert 6 mm screws in the holes, making sure their heads protrude 2.5 to 3 mm from
the wall and mount the telephone onto the screws.
Labelling the Keys
The five keys to the right of the display of the OpenPhone 63can be programmed as
call keys or programmed with destinations or functions. The programming/
assignment does not appear in the display. The OpenPhone 61 has five program-
mable keys
below the
Inserting Label Strips
Label strips are supplied for the corresponding labelling. Proceed as follows to label
the insert:
•
Press down slightly on the bottom part of the cover, sliding it downwards so that
the top part of the cover snaps out and you can remove this and take out the label
strip. On the OpenPhone 61 slide the cover to the right to remove it.
•
Replace the printed strips.
•
To replace the cover, insert it in the slot, then slide it down and finally slide it up
until the catches snap into place. On the OpenPhone 61 you place the cover in the
slot and slide it to the left until it snaps into place.
10
display. Their assignment also does not have display support.
120 mm
155 mm
184 mm
Advertisement
Table of Contents
