Mounting And Removing Lens Ports - Fantasea Line FA6500 V2 Instruction Manual

MOUNTING AND REMOVING LENS PORTS
The housing features an FML interchangeable lens port system, which allows using a wide range of
lenses underwater. The housing is compatible with any FML lens port, as well as other lens ports
available in the market. For compatibility information and lens ports available, please visit the Fantasea
website – www.fantasea.com
1. Mounting a lens port on the housing:
a. If possible, it is recommended to mount the lens port on the housing prior to installing
the camera inside. If using exceptionally large lenses which cannot be installed on the
camera prior to inserting it into the housing, the camera and lens can be installed inside
the housing prior to mounting the lens port. Please refer to section "Installing the
Camera" - step 18.
b. For smooth installation and
removal of the lens port, it is
recommended to apply a slight
amount of Fantasea Silicone
Grease over the lens port O-ring
prior to installing it on the
housing.
c. Turn the lens port lock rightwards,
so it's seated at the "UNLOCK"
position (image #32).
d. Remove the body cap from the
housing lens port hole. Store for
future use.
e. Hold the lens port against the
housing port hole and align the
white line marking on the lens
port with the white line marking
on the housing (image #33).
f. Carefully push the lens port
against the housing until it's fully
inserted inside the port hole.
Examine the lens port from all
directions to make sure it was evenly inserted.
Image #32
Image #33
FA6500 V2 Housing Instruction Manual 20190402
27