Mounting And Removing Lens Ports - Fantasea Line FA6400 Instruction Manual

2. Store the cover for possible future use.
3. Follow the instructions provided with the selected accessory product in order to install it
inside the housing and make sure the M16 port accessory installed consists of an O‐ring for
maintaining the watertight seal of the housing.
Important
Note
MOUNTING AND REMOVING LENS PORTS
The housing features an FML interchangeable lens port system, which allows using a wide range of
lenses underwater. The housing is compatible with any FML lens port, as well as other lens ports
available in the market. For compatibility information and lens ports available, please visit the Fantasea
website – www.fantasea.com
1. Mounting a lens port on the housing:
a. If possible, it is recommended to mount the lens port on the housing prior to installing
the camera inside. If using exceptionally large lenses which cannot be installed on the
camera prior to inserting it into the housing, the camera and lens can be installed inside
the housing prior to mounting the lens port. Please refer to section "Installing the
Camera" ‐ step 18.
b. For smooth installation and
removal of the lens port, it is
recommended to apply a slight
amount of Fantasea Silicone
Grease over the lens port O‐ring
prior to installing it on the
housing.
c. Turn the lens port lock
rightwards, so it's seated at the
"UNLOCK" position (image #13).
d. Remove the body cap from the
housing lens port hole. Store for
future use.
Once an accessory has been installed using the M16 port, it important to
carry out the first dive with the housing empty (no camera installed
inside) in order to verify that the housing watertight seal has not been
affected during the replacement
Image #13
20
FA6400 Housing Instruction Manual 20190416