NEC XN120 Getting Started Manual page 60

Making Changes to the Configuration
Trunk groups and order
1. Click on 14-xx to expand tree
2. Click on 14-05
3. Edit trunk group and priority
4. Save changes (Apply)
5. Click 14-xx to close tree
To add analogue lines back in to configuration
Analogue trunks are placed into trunk group 25 within the ISDN pre config. If you want to put
any analogue trunks back into the group for outgoing trunk access then include group 25 into
Route table 01 as shown below.
1. Edit 14-06 - priority 2 = from 0 to 25
2. Save changes (Apply)
Definitions
21-02 – Route table = which trunk route is selected for each mode of service, per extension.
14-06 – Input data = for each route, select order of trunk groups.
14-05 - Trunk group = 0 to 25
14-05 – Priority = order which trunks are selected
60