NEC XN120 Getting Started Manual page 22

PCPro Via DDI to 830
3. Connect the modem to the EXIFU serial port / telephone port
·
Plug the serial port of the modem to the serial port of the EXIFU card with a straight serial
cable.
·
Plug the telephone port of the modem into one of the ST ports of the XN120 system.
Make a note of the extension number of the ST port (use Program 11-02-01 to get the
extension number).
·
Power on the modem.
·
Confirm the Auto-Answer lamp lights on the modem.
4. Setup the remote access dial in method
There are two methods available to route the remote access call to the modem.
·
Route the trunk directly to the modem.
ISDN DDI
If you have a spare DDI route this to the extension number of the ST port connected to the
modem.
Remember to set the DDI routing for all night modes that are in use!
Analogue trunk
Route one of the trunks to the extension number of the ST port connected to the modem.
This could be via a ring group, DUD/Auto-Attendant.
Place a call to the normal line and be transferred to the modem by a user.
5. Setup the dial up session on your PC
Before creating the dial up session ensure that your modem is installed and available on your
PC.
Creating a Dial Up Session for Remote Access via a Modem.
1. Click Start -> Settings -> Network
Connections and select Create New
Connection
2. In the New Connection screen click Next
22