Installing Vertical Stabilizer - Seagull Models steen skybolt n250sb Assembly Manual

INSTALLING VERTICAL STABILIZER

1) Using a modeling knife, remove the
covering from over the precut hinge slot cut
into the lower rear portion of the fuselage.
Fill Epoxy
WWW.SEAGULLMODELS.COM
2) While holding the vertical stabilizer
firmly in place, use a pen and draw a
line on each side of the vertical stabilizer
where it meets the top of the fuselage.
Epoxy
3) Slide the vertical stabilizer back in-
place. Using a triangle, check to ensure
that the vertical stabilizer is aligned 90º
to the horizontal stabilizer.
Horizontal
90º
Stabilizer.
Epoxy
Vertical
Stabilizer.
C/A glue.
Hinge.
21