Seagull Models steen skybolt n250sb Assembly Manual page 29

2) Attach the wing strut to the top of the
bottom wing panel using an M3x12 ma-
chine screw.
3) Repeat steps to prepare the remaining
wing panel for installation.
4) Thread a clevis on each end of a thre-
added rod. Connect the rod between the
top and bottom ailerons. With the radio
system on and the bottom aileron con-
tered, adjust the length to center the top
aileron.
WWW.SEAGULLMODELS.COM
3x12mm
3x12mm
Once centered, slide the silicone tubing
over the forks of the clevis to prevent it
from opening accidentally. Apply thread-
lock on the nuts and clevises to prevent
them from vibrating loose. Use needle
nose pliers to tighten the nut against the
clevis to prevent it from vibrating and
changing position.
29