Table of Contents
Advertisement
AILERON PU SHROD HORN
INSTALLATION.
Please see below pictures.
Use a felt tip pen to mark the wire where
it crosses the hole. Use a pair of pliers to
put a shrp 90-degree bend in the wire at
the mark.
Bend at the mark
M2 lock nut.
8mm
Snap keeper.
Servo arm.
Snap keeper.
WWW.SEAGULLMODELS.COM
Mark.
.
Metal clevis.
Nylon Snap keeper.
Fuel tubing.
INSTALLING THE HORIZONTAL
STABILIZER.
1) Using a ruler and a pen, locate the cen-
terline of the horizontal stabilizer, at the
trailing edge, and place a mark. Use a tri-
angle and extend this mark, from back to
front, across the top of the stabilizer. Also
extend this mark down the back of the
trailing edge of the stabilizer.
2) Using a modeling knife, carefully re-
move the covering at mounting slot of
horizontal stabilizer ( both side of fuse-
lage).
Hex Nut.
Draw center line
19
Advertisement
Table of Contents
