Installing The Fuselage Servos - Seagull Models steen skybolt n250sb Assembly Manual

STEEN SKYBOLT
Epoxy.
Rudder fiberglass control horn.

INSTALLING THE FUSELAGE SERVOS.

Because the size of servos differ, you
may need to adjust the size of the precut
opening in the mount. The notch in the
sides of the mount allow the servo lead to
pass through.
1) Install the rubber grommets and brass
collets onto the throttle servo. Test fit the
servo into the aileron servo mount.
2) Secure the servos with the screws pro-
vided with your radio system.
Elevator servo.
Rudder servo.
6
.
Throttle servo.
Instruction Manual.
THROTTLE SERVO ARM
INSTALLATION.
Install adjustable servo connector in the
servo arm as same as picture below:
Loctite secure.
INSTALLING THE RECEIVER SWITCH.
Install the switch into the precut hole in
the side, in the fuselage.
Adjustable servo
connector.
Servo arm.
Throttle servo arm.
3/32" Hole.
Trim and cut.