Apply The Decals; Cabane Strut Installation - Seagull Models steen skybolt n250sb Assembly Manual

3) Position the pilot figure on the canopy
floor as shown. Use epoxy to glue the base
of the pilot figure to the cockpit floor,
please see pictures as shown.
Glue the cockpit instrument panel in
place with C/A glue, please see pictures as
shown.
Epoxy.
20mm
4) Position the canopy onto the fuselage.
Trace around the canopy and onto the
fu¬selage using a felt-tipped pen. Care-
fully cut and remove covering mate-
rial from the fusealge where the canopy
makes contact, exposing the bare wood.
The permanently glue the canopy in place
with epoxy glue or special "canopy glue".
Epoxy
WWW.SEAGULLMODELS.COM
.

APPLY THE DECALS.

1) If all the decals are precut and ready to
stick. Please be certain the model is clean
and free from oily fingerprints and dust.
Position decal on the model where de-
sired, using the photos on the box and aid
in their location.
2) If all the decals are not precut, please
use scissors or a sharp hobby knife to cut
the decals from the sheet. Please be cer-
tain the model is clean and free from oily
fingerprints and dust. Position decal on
the model where desired, using the pho-
tos on the box and aid in their location.

CABANE STRUT INSTALLATION.

1) Locate the items for this section of the
manual.
2) Use a hobby knife with blade to re-
move the covering on the top of the fuse-
lage so the cabane struts can be inserted
into the fuselage. We recommend using a
trim seal tool to iron the covering neatly
into the openings in the fuselage.
3x12mm
25