Seagull Models steen skybolt n250sb Assembly Manual page 26

STEEN SKYBOLT
3) Place the cabane struts on position ,not-
ing their position as shown in the photo.
Loosely install the four M3x12 socket head
machine screws and M3 washers.Leave ,
the hardware loose so the struts can be
positioned while installing the upper wing
center rib.Maker sure to use threadlock
on the screws so they won't vibrate loose.
4) Place the upper center wing rib in
position on the cabane struts. Start the
M3x12 socket head screws that secure
the rib to the cabane struts.
26
3x12mm
3x12mm
Instruction Manual.
5) Use a 2.5mm hex wrench to slowly
tighten the hardware securing the cabane
struts in position on the fuselage.You
may want to use hemostats to hold the
M3 nuts when using them to attach the
upper center wing rib to the struts .Again
,make sure to use threadlock on all the
fastenners to prevent them from vibrat-
ing loose.
3x12mm
INSTALLING BATTERY - RECEIVER.
1) Plug the five servo leads and the switch
lead into the receiver. Plug the battery
pack lead into the switch also.
2) Wrap the receiver and battery pack in
the protective foam rubber to protect
them from vibration.
Receiver with
two-side tape.
Battery with
two-side tape.