Seagull Models steen skybolt n250sb Assembly Manual page 12

STEEN SKYBOLT
INSTALLING THE MAIN LANDING
GEAR TO FUSELAGE.
1) The blind nuts for securing the land-
ing gear are already mounted inside the
fuselage.
2) Using the hardware provided, mount
the main landing gear to the fuselage.
3) Place the fuselage inverted on the
workbench in a suitable stand. Set the
landing gear in place and use a screw-
drive to secure the landing gear to the fu-
selage using bolts M4x20mm and wash-
ers. Make sure to use the threadlock on
the bolts so they don't vibrate loose.
12
Instruction Manual.
Thread locker glue.
M4x20mm
WHEELS AND WHEEL PANTS.
1) Locate the items neccessary to install
2) Follow diagram below for wheel pant
installation:
Use a drill and 8mm drill bit to drill a
hole in the wheel pants.
Drill a hole.
8mm
14mm
3) Trim each axle to correct length, us-
ing a rotary tool with an abrasive cut-off
wheel.
M4x20mm
.