Blade Tension Assembly; Band Drive Assembly; Guide Arms; Band Brush Assembly - DoAll C-530 NC Instruction & Parts Manual

14.2.4 Blade tension assembly

Blade tension assembly Dwg. 210/16
Adjust the guide track
Check locknut
Do not regulate the central screw of the blade tension guide

14.2.5 Band drive assembly

Band drive assembly dwg. 210/03
Check the electrical motor
Check the collect locking that connect the wheel to the reducer shaft
Check belts

14.2.6 Guide arms

Check guide arms dwg. 210/05
Check carbide inserts
When changing the blade, clean the inserts with gasoline
Check, and if necessary replace, the guiding ball bearings and the guide-arm inserts
Check and rotate the carbide backer

14.2.7 Band brush assembly

Band brush assembly dwg. 210/20
Check and if necessary replace the band brush
Register the brush so to keep the blade teeth always clean

14.2.8 Wheels

Check the wheel adjustment
Check the blade position on the wheel. If the blade back touches the wheel, call the manu-
facturer.
Check and keep clean the wheel grooves
Be sure the blade is not cutting the machine frame
Keep lubricated all the bearings

14.2.9 Servo-cutting device

Servo cutting assembly Dwg. 066/17
Check the servo-valve adjusting the cutting pressure. Turn the knob
Open the servo-valve cover and check the vertical movement of the unit.
14.2.10 Rapid approach
Check that the rapid approach limit switch is in working properly
14.3 COOLA T SYSTEM
Check the reservoir level and, if necessary, add oil type OSO46.
14.4 HYDRAULIC POWER U IT
Keep the pressure to 50 bar.
Instruction & Parts Manual
Wheel. 03-042-0
Edition 2008-A
Pos. Tool
Spanner
03-052
Pos. Tool
03-001
03-043
03-019
Pos. Tool
05-045
05-023
05-026-029
17-003
Pos. Tool
20-014 Spanner
Pos. Tool
03-042 Manufacturer
03-042
03-042 Manufacturer
03-051
Pos. Tool
Spanner
Pag.44