Select Your Country Language; Alarms List; Material Library - DoAll C-530 NC Instruction & Parts Manual

12.1.10 Select your country language

To change the display language, press the buttons
pressing ENTER. Then select:
For ITALIAN
1
2 For ENGLISH
3 For DANISH
For CZECH
4
5 For SPANISH
6 For FRENCH
For GERMAN
7
8 For DUTCH

12.1.11 Alarms list

E01 Emergency
E02 Band drive overload
E03 Hydraulic's overload
E04 Coolant overload
E05 Chip conveyor overload
E06 Blade deviation
E07 Blade broken
E08 Band covers open
E09 Hydraulic's off
E12 Inverter fault
E16 Blade under fast approach
E23 Index cover open
E85 Low rotation
E87 Cut time out
E97 Persa EE (parametri cfg)
E98 Memoria programmi persa
E102 Load time out

12.1.12 Material library

To set up your personal material library is easy and conveninete, since it will allow to prepare your
programs in an easy way and avoiding to do mistakes. To prepare your customized material library:
To access the machine configuration menus
SAW 4 programming section
Material library configuration
Password 301768
Material enable. Enable all necessary materials (max 12) by pressing 1 on each material.
Now you should set up the correct cutting parameters for each material
Instruction & Parts Manual
- Reset emergency pushbutton
- Reset overload relay
- Reset overload relay
- Reset overload relay
- Reset overload relay
- Check blade conditions
- Reset band deviation monitor
- Replace the blade
- Close band wheel protections
- Check position of the blade replacement key
- Start hydraulic's
- Call DoAll service department
- Raise the saw head
- Close index covers
- Check if band stall sensor is dirty
- Call DoAll service department
- Check time out set-up in the parameters list
- Call DoAll service department
- Call DoAll service department
- Check time out set-up in the parameters list
, and then
Pag.32
Edition 2008-A
. Type 123456 and confirm it by