Remai I G Da Gers; Perso El Trai I G; Machi E Disma Tle - DoAll C-530 NC Instruction & Parts Manual

Table of Contents

16. REMAI I G DA GERS

This machine is powered by electrical power. The manufacturer, building the machine, used the state of the art solutions

also meeting the regarding regulations to assure maximum safety to the operator.

When servicing the machine with power on to check particular electrical components, always respects the basic safety

rules. Reduce as much as possible this type of operations.

The customer is required to provide a suitable power source respecting the CEI 64-8 or other countries special rules

where the machine was installed.

This machine was design to be easily operated. It is not expressly required an expert to operate the saw, but an expert can

set as best as possible the machine so to obtain the maximum results.

Therefore, the operator needs a good experience in machine tools, especially in band saw machine.

The internal maintenance personnel should be able to read and understand an electrical and hydraulic schematic, and

work on the machine following the instructions contained in the schematics.

This machine was built using only ecological materials. It is necessary to separately recycle only the hydraulic oils and the

coolant liquid.

Instruction & Parts Manual

Pag.48

Edition 2008-A

Table of Contents