Table of Contents
Advertisement
2.1 M
AI COSTRUCTIVE CHARACTERISTICS
The machine uses :
• NC controller with operator display and 32 customizable function keys integrated.
• Multi language diagnostic with info messages.
• Material libraries.
• Band speed readout integrated.
• Constant feed pressure control.
• Band wheel drive with AC inverter and planetary reducer.
• Automatic guide arm.
• Carbide faced saw guides with large diameter lead in rollers on both guide arms.
• Automatic chip conveyor.
• Hardened, ground, anti-wear steel plates on all work clamping surfaces.
• Ground, hardened and hard-chrome plated guide columns.
• Power driven band cleaning brush.
• Hydraulic band tension.
• Recirculating, coolant system, pump 400/50/3, applied through nozzle.
• Chip container.
• Rapid saw head approach control.
• Out of stock sensor.
• Band wheel door interlocks.
• Blade guards.
• Automatic band kerf compensator.
• C26 gray iron castings
The saw is built to work in automatic also without an operator. A special vise design allows the machine to cut slightly irre-
gular bars.
2.2. B
LADE SPEED
The blade speed is controlled by an AC motor and a variable frequency drive, which allow to regulate the blade speed within
a range of 0- 100 m/1'. In this way the machine can cut both hard steels and aluminum. A digital reader constantly shows the
blade speed .
The blade speed can be adjusted :
• in automatic cycle while editing the program;
• anytime, by pressing the
2.3. W
ORKI G SURFACE
The material that has to be cut lays on a roller way that covers the entire stroke of the machine. The distance between the roll-
ers is studied to avoid that short pieces can fall.
Instruction & Parts Manual
.
keys on the control panel.
Pag.10
Edition 2008-A
Advertisement
Table of Contents
