Use Of The Machi E; How To Use The Machine - The Saw 4 Control; What The Saw 4 Is; Switching The Saw 4 On - DoAll C-530 NC Instruction & Parts Manual

Hide thumbs Also See for C-530 NC:
Table of Contents

Advertisement

12. USE OF THE MACHI E

The manufacturer cannot be liable for any injury caused by errors or mistake using the
machine, as described in the following paragraphs.
The operator must wear all the personal protections equipments, as gloves and ear plugs.
Loading the material onto the machine
Moving bars, especially if they are in bundles, it is necessary to pay attention to the se-
curity rules for the movement of heavy loads.
Keep the bundle with steel strips until it is in the vises, then remove the strap before
starting the cutting cycle.
12.1. H
OW TO USE THE MACHI E

12.1.1 What the Saw 4 is

The Saw 4 is a PLC & a NC control, specifically designed for cutting machines. All the machine
operations are controlled by the Saw 4: in manual by pressing the pushbuttons correspondent to the
desired operation, and in automatic by the programmed logic.
LCD display
SHIFT & Contrast adjustment
Manual mode pushbuttons
12.1.2 Switching the Saw 4 O
Rotate the main disconnect switch (located
on the electrical cabinet front door) in
position "1" to give power to the machine
electrics.
Once the electrics are on, to switch the
Saw 4 on press the ( I ) pushbutton located on
the side of the control . It will appear for few
seconds the ISTECH welcome logo, then the
machine will ask if it's necessary to set the zero
Instruction & Parts Manual
– T
S
4
HE
AW
CO TROL
STOP pushbutton
Numeric keyboard
Pag.24
Edition 2008-A
PGM & RUN pushbuttons
START pushbutton

Advertisement

Table of Contents
loading

Table of Contents