Table of Contents
Advertisement
12.1.7.2 Create a new cutting program
The
allows to make a new program. To edit a new cutting program it is required to enter the
following programs:
Program name
Crop cut
Material type
Dimension
To move on the editing screen, use the arrows on the top right corner of the SAW 4 control. All the
figures typed must be confirmed by pressing the ENTER button.
The control, when editing the program, gives a numeric name by default to the program. This num-
ber follows the last one written in the control memory. By moving with the pointer on the name
field, the operator can modify the program name as he prefers.
The automatic screen gives also other important informations to the operator, like:
1. N
ECESSARY BAR LENGTH
the number of cuts, to the blade kerves and the minimum butt end. I.e.: (30 mm x 50 Pc) +
(1,6 mm x 50 pc) = 1580.0
• T
OTAL NUMBER OF CUTS TO DO
• A
LREADY DONE CUTS
Also, the bottom part of the screen shows the following icons which allow to:
Delete the cutting line underlined
Insert a new cutting line where the cursor is at the moment
To delete all the lines of a program
To go to the first page of the program
To go to the last page of the program
To save
12.1.7.2.1 How proceed to create your working list (Only for material handling)
To create the list of programs to execute, it is necessary that the material handling icon would be on
ON or in AUTO mode (on the screen will appear the icon
button "F28".
Select the programs directory(
trol. Go to the line showing the first program to execute and press INS button (lower right corner of
the screen), then do the same for the following programs.
Press RUN and it will appear the current job list.
Instruction & Parts Manual
Alfa
316L
I :10
50-100
1
30.0
2
Len:
1580.0
to run the program. The SAW 4 adds the cutting lengths, times
(50 in the example);
(0 in the example).
) and it will appear the entire list of programs stored in the con-
70m/m
27%
50
Cut length
50
0
or
). To enable this icon, press
Pag.28
Edition 2008-A
Band speed
Feed force
Number of cuts
Advertisement
Table of Contents
