How To Reset The Automatic Workstop Sensor; Band Deviation Monitor (Option) - DoAll C-530 NC Instruction & Parts Manual

12.3.1 How to reset the automatic workstop sensor

If the first cut is too short or too long, then it is required to reset the automatic workstop sensor. To
do so:
Press the SET button
Press the button
123456 Enter the password and press OK
Parameter 13 gives the distance between the sensor and the blade. If the cut is too
short, reduce the set value of the difference in length (i.e. if 298 instead of 300, reduce
the set value by 2 mm). If the cut is to long, increase the set value of the difference in
length.
Exit the parameter area by pressing OK, then EXIT
12.4. BA D DEVIATIO MO ITOR (OPTIO )
Band deviation monitor, when combined with CNC option, has 2 deviation limits the operator can
set to control straightness of the cut:
- Feed reduction limit: when band deviation reaches this limit, head feed is reduced (this first
limit is not available on machine with manual feed control, but only on CNC ones);
- Out of tolerance limit: when band deviation reaches this second limit, machine completely
stops and error messages displays on the screen.
To set the "F
EED REDUCTION LIMIT
Press the button
Press the button
Press the button
123456 Enter the password and press OK
MORE Press the button 3 times
Press the button
Set the parameter "Deviation tolerance" to the desired value
Exit the parameter area by pressing OK, then EXIT
To set the "
OUT OF TOLERANCE
Press the button
Press the button
Press the button
123456 Enter the password and press OK
MORE Press the button 3 times
Press the button
Set the parameter "Max deviation" to the desired value
Exit the parameter area by pressing OK, then EXIT
To set the "
FEED REDUCTION
Press the button
Press the button
Press the button
123456 Enter the password and press OK
MORE Press the button 3 times
Instruction & Parts Manual
" band deviation monitor:
" band deviation monitor:
" when reached the feed reduction limit:
Pag.36
Edition 2008-A