Calibratioa Dtu E - Up; Calibration; Machine Tuning-Up; Blade Motor Inverter - DoAll C-530 NC Instruction & Parts Manual

Press the button
Set the parameter "% feed reduction" to the desired value
Exit the parameter area by pressing OK, then EXIT
13. CALIBRATIO A D TU E-UP
2.
13.1. C
ALIBRATIO
No calibration is needed, because the machine was calibrated by the manufacturer.
13.2. M
ACHI E TU I G
No tuning-up is needed, because the machine was tuned-up by the manufacturer.
13.3. B
LADE MOTOR I VERTER

13.3.1 Control panel

All functions of the inverter can be controlled by way of the ACM-D2 control panel. The 4 input
keys allow control of the motor and direct parameter programming. The functions are separated
into three levels in order to facilitate programming (function tables TAB1, TAB2, TAB3).
TAB1 Programming of the basic parameters of
the inverter and call-up of works settings.
TAB2 Configuration of the analog and digital
inputs, programming of the output vol-
tage and of the SECURITY function.
TAB3 Configuration of the analog and digital
outputs, the extended setting functions
and call-up of the diagnosis function.
B
UTTO S
Instruction & Parts Manual
-
UP
Function interrogation forward.
Function interrogation back.
D
ESCRIPTIO
Pag.37
Edition 2008-A