Signet Charger Operation, Model Hb Series; Signet Charger Operation, Model Hbs Series - Taylor-Dunn B0-248-48AC Operation, T Roubleshooting And Replacement Parts Manual

SAFETY RULES AND OPERATING INSTRUCTIONS

Signet Charger Operation, Model HB Series

The Signet ® HB series chargers use a semi-automatic charging system. The
charger will turn itself ON when the AC power cord is connected to the AC power
source and turn itself OFF when the batteries are fully charged. Refer to the data
plate on the charger for the voltage and type power required for the charger.
There is a series of LED's on the faceplate of the charger that serve two functions:
1. Status of charge. The LED's will display an approximate percent of charge
during the charging cycle. Refer to the table below.
2. Error condition. All three LED's flashing is an
indication of a charging problem (charger will also
be beeping).
Troubleshooting section for information on error
codes.

Signet Charger Operation, Model HBS series

The Signet ® HBS series chargers are fully automatic. The charger will turn itself ON when the AC power cord
is connected to the AC power source and turn itself OFF when the batteries are fully charged. Once the
charge cycle is complete, the charger will continue to monitor the batteries. If the battery voltage drops
during storage, the charger will start a new cycle to keep the batteries fully charged.
NOTE: If the charger restarts during a short time period of
storage, then it would be an indication of faulty
batteries.
Refer to the data plate on the charger for the voltage and type power required
for the charger.
There is a series of LED's on the faceplate of the charger that serve two
functions:
1. Status of charge. The STATUS LED's will display an approximate percent of charge during the
charging cycle. Refer to the table below.
2. Error condition. The FAULT LED flashing is an indication of a charging problem (charger may also
be beeping). Refer to the Charger Troubleshooting section for information on error codes.
Lestronic II ® Charger Operation
®
The Lestronic II charger is a semiautomatic charging system. The charger
will turn itself ON when the AC power cord is connected to the AC power
source and turn itself OFF when the batteries are fully charged. Refer to the
data plate on the charger for the voltage and type power required for the
charger.
When the charger is plugged in, it should turn on within a few seconds. To
determine if the charger is on, listen for a humming sound from the charger.
If the charger does not turn on, then there may be a fault in the AC line
voltage or in the charger. Refer troubleshooting to a qualified technician.
Typical charging times are eight to twelve hours depending on the how deep the batteries are discharged.
Charging times exceeding 16-hours may be a result of faulty batteries, faulty charger, noisy or fluctuating
AC line voltage, or momentarily interrupting the charging cycle. Refer troubleshooting to a qualified
technician.
Refer to the Charger
Safety Rules
LED1
Charging State
0 to 50% Blinking
50% to 75% ON
75% to 100% ON
Cycle complete ON
Typical Lestronic II
Page 15
LED2 LED3
OFF OFF
Blinking OFF
ON Blinking
ON ON
Built In
®