Signet Charger Operation (Model Hbs) - Taylor-Dunn SS-025-34 Operation, Maintenance, And Replacement Parts Manual

SAFETY RULES AND OPERATING INSTRUCTIONS

Signet Charger Operation (Model HBS)

The Signet ® HBS series chargers are fully automatic.
The charger will turn itself ON when the AC power cord
is connected to the AC power source and turn itself OFF
when the batteries are fully charged. Once the charge
cycle is complete, the charger will continue to monitor
the batteries. If the battery voltage drops during storage,
the charger will start a new cycle to keep the batteries
fully charged.
NOTE: If the charger restarts during a short time period
of storage, then it couldbe an indication of faulty
batteries.
Refer to the data plate on the charger for the voltage
and type power required for the charger.
There is a series of LED's on the faceplate of the charger
that serve two functions:
1. Status of charge. The STATUS LED's will display
an approximate percent of charge during the
charging cycle. Refer to the table below.
2. Error condition. If the FAULT LED is on or
flashing, it is an indication that a problem occured
during the charge cycle (charger may also be
beeping). Refer to the Charger Troubleshooting
section for information on error fault codes.
LED1
Charging State
0 to 50% Blinking
50% to 75% ON
75% to 100% ON
Cycle complete ON
Safety Rules
Page 10
LED2 LED3
OFF OFF
Blinking OFF
ON Blinking
ON ON
Lestronic II Charger Operation
®
The Lestronic II ® charger is a semi-automatic charging
system. The charger will turn itself ON when the AC
power cord is connected to the AC power source and
turn itself OFF when the batteries are fully charged. Refer
to the data plate on the charger for the voltage and type
power required for the charger.
When plugged in, the charger assumes that the batteries
require charging and will charger for a minimum of
approximately 4-hours. This charger should not be
plugged in until the batteries are discharged beyond 50%
or the batteries may be overcharged.