17. Install the locking roll pins into the housing and cover to lock the ring nuts in place.
18. Remove the pinion gear holding tool.
19. Install the primary reduction gear case, axles and housings, motor, and install the complete
drive onto the vehicle.
20. Fill the drive with oil. Refer to the
Change Oil
Refer to
21. Lower the vehicle.
22. Reconnect the main positive and negative cables at the batteries.
23. Remove the blocks from behind the wheels.
24. Test drive the vehicle.
Maintenance, Service, and Repair
Lube Chart
section for information regarding the proper oil level..
Transmission
Page 17
section for information regarding type of oil.