Cisco 500 series Administration Manual page 471

RIP
Configuring RIP
STEP 1
STEP 2
Cisco 500 Series Stackable Managed Switch Administration Guide
To create access lists, do the following:
1. Create an access list with a single IP address, using the Access List Settings
page.
2. Add additional IP addresses if required, using the Source IPv4 Address List
page.
Creating an Access List
To set the global configuration of an access list.
Click IP Configuration > Access List > Access List Settings. The Access List
Settings page is displayed.
To add a new Access List, click Add to open the Add Access List page and enter
the following fields:
• Name—Define a name for the access list.
• Source IPv4 Address—Enter the source IPv4 address. The following
options are available:
- Any—All IP addresses are included.
- User Defined—Enter an IP address.
• Source IPv4 Mask—Enter the source IPv4 address mask type and value.
The following options are available:
- Network Mask—Enter the network mask.
- Prefix Length—Enter the prefix length.
• Action—Select an action for the access list. The following options are
available:
- Permit—Permit entry of packets from the IP address(es) in the access
list.
- Deny—Reject entry of packets from the IP address(es) in the access list.
27
471