Window Navigation - Cisco 500 series Administration Manual

Getting Started

Window Navigation

Window Navigation
Cisco 500 Series Stackable Managed Switch Administration Guide
• Enabling IPv4 routing is done differently in the two types of devices, as
follows:
- SG500X—IPv4 routing must be enabled in the IPv4 Interface page.
- Sx500—When the device is switched from Layer 2 to Layer 3 system
mode, IPv4 routing is automatically enabled.
This section describes the features of the web-based switch configuration utility.
Application Header
The Application Header is displayed on every page. It provides the following
application links:
Application Links
Application Link
Name
Username
Description
A flashing red X icon displayed to the left of the Save
application link indicates that Running Configuration
changes have been made that have not yet been saved to
the Startup Configuration file. The flashing of the red X can
be disabled on the Copy/Save Configuration page.
Click Save to display the Copy/Save Configuration page.
Save the Running Configuration file by copying it to the
Startup Configuration file type on the switch. After this
save, the red X icon and the Save application link are no
longer displayed. When the switch is rebooted, it copies
the Startup Configuration file type to the Running
Configuration and sets the switch parameters according to
the data in the Running Configuration.
Displays the name of the user logged on to the switch. The
default username is cisco. (The default password is cisco).
1
17