Cisco 500 series Administration Manual page 469

RIP
Configuring RIP
STEP 3
STEP 1
Cisco 500 Series Stackable Managed Switch Administration Guide
- Text—The key password entered below is used for authentication.
- MD5—The MD5 digest of the key chain selected below is used for
authentication.
• Key Password—If Text was selected as the authentication type, enter the
password to be used.
• Key Chain—If MD5 was selected as the authentication type, enter the key
chain to be digested. This key chain is created as described in the
Management
• Default Route—Specifies whether RIP generates a default route on the
specified IP interface. If this is enabled, the Metric field is enabled.
• Default Route Metric—Specifies the metric for the default route.
• Distribute-list In—Specifies whether filtering is enabled/disabled for RIP
incoming routes for the specified IP address(es) list. If this field is enabled,
select the Access List Name below.
• Access List Name—Specifies the Access List name (which includes a list of
IP addresses)) of RIP incoming routes filtering for a specified IP interface.
See Creating an Access List
• Distribute-list Out—Specifies whether filtering is enabled/disabled for RIP
outgoing routes for the specified IP address(es) list. If this field is enabled,
select the Access List Name below.
• Access List Name—Specifies the Access List name (which includes a list of
IP addresses)) of RIP outgoing routes filtering for a specified IP interface. See
Creating an Access
Click Apply. The settings are written to the Running Configuration file.
Displaying RIP Statistic Counters
To view the RIP statistical counters for each IP address:
Click IP Configuration > RIPv2 > RIPv2 Statistics. The RIPv2 Statistics page is
displayed.
The following fields are displayed:
• IP Interface—IP interface defined on the Layer 2 interface.
section.
for a description of access lists.
Listfor a description of access lists.
27
Key
469