Cisco 500 series Administration Manual page 314

Configuring Security
Defining Management Access Method
Cisco 500 Series Stackable Managed Switch Administration Guide
- Telnet—Users requesting access to the switch that meets the Telnet
access profile criteria are permitted or denied access.
- Secure Telnet (SSH)—Users requesting access to the switch that meets
the Telnet access profile criteria, are permitted or denied access.
- HTTP—Assigns HTTP access to the rule. Users requesting access to the
switch that meets the HTTP access profile criteria, are permitted or
denied.
- Secure HTTP (HTTPS)—Users requesting access to the switch that
meets the HTTPS access profile criteria, are permitted or denied.
- SNMP—Users requesting access to the switch that meets the SNMP
access profile criteria are permitted or denied.
• Action—Select Permit to permit the users that attempt to access the switch
by using the configured access method from the interface and IP source
defined in this rule. Or select Deny to deny access.
• Applies to Interface—Select the interface attached to the rule. The options
are:
- All—Applies to all ports, VLANs, and LAGs.
- User Defined—Applies only to the port, VLAN, or LAG selected.
• Interface—Enter the interface number.
• Applies to Source IP Address—Select the type of source IP address to
which the access profile applies. The Source IP Address field is valid for a
subnetwork. Select one of the following values:
- All—Applies to all types of IP addresses.
- User Defined—Applies to only those types of IP addresses defined in
the fields.
• IP Version—Select the supported IP version of the source address: IPv6 or
IPv4.
• IP Address—Enter the source IP address.
• Mask—Select the format for the subnet mask for the source IP address, and
enter a value in one of the field:
- Network Mask—Select the subnet to which the source IP address
belongs and enter the subnet mask in dotted decimal format.
18
314