Cisco 500 series Administration Manual page 414

Stackable managed switch
Hide thumbs Also See for 500 series:
Table of Contents

Advertisement

Configuring Quality of Service
QoS Features and Components
STEP 1
STEP 2
Cisco 500 Series Stackable Managed Switch Administration Guide
The header field to be trusted is entered in the
every value of that field, an egress queue is assigned where the frame is
CoS/802. 1 p to Queue
sent in the
(depending on whether the trust mode is CoS/802. 1 p or DSCP,
respectively).
Advanced Mode—Per-flow Quality of Service (QoS).
In advanced mode, a per flow QoS consists of a class map and/or a policer:
-
A class map defines the kind of traffic in a flow, and contains one or more
ACLs. Packets that match the ACLs belong to the flow.
-
A policer applies the configured QoS to a flow. The QoS configuration of
a flow may consist of egress queue, the DSCP or CoS/802. 1 p value, and
actions on out of profile (excess) traffic.
Disable Mode—In this mode all traffic is mapped to a single best effort
queue, so that no type of traffic is prioritized over another.
Only a single mode can be active at a time. When the system is configured to work
in QoS Advanced mode, settings for QoS Basic mode are not active and vice
versa.
When the mode is changed, the following occurs:
When changing from QoS Advanced mode to any other mode, policy profile
definitions and class maps are deleted. ACLs bonded directly to interfaces
remain bonded.
When changing from QoS Basic mode to Advanced mode, the QoS Trust
mode configuration in Basic mode is not retained.
When disabling QoS, the shaper and queue setting (WRR/SP bandwidth
setting) are reset to default values.
All other user configurations remain intact.
QoS Workflow
To configure general QoS parameters, perform the following:
Choose the QoS mode (Basic, Advanced, or Disabled, as described in the
Modes"
section) for the system by using the
steps in the workflow, assume that you have chosen to enable QoS.
Assign each interface a default CoS priority by using the
Global Settings
DSCP to Queue
page or the
QoS Properties
QoS Properties
25
page. For
page
"QoS
.
page
The following
page.
414

Advertisement

Table of Contents
loading

Table of Contents