Cisco 500 series Administration Manual page 139

Configuring Discovery
Configuring CDP
STEP 2
STEP 3
Cisco 500 Series Stackable Managed Switch Administration Guide
The bottom of the page has four buttons:
• Copy Settings—Select to copy a configuration from one port to another.
• Edit—Fields explained in Step 2 below.
• CDP Local Information Details—Takes you to the
- CDP > CDP Local Information
• CDP Neighbor Information Details—Takes you to the
Discovery - CDP > CDP Neighbor Information
Select a port and click Edit. The Edit CDP Interface Settings page opens.
This page provides the following fields:
• Interface—Select the interface to be defined.
• CDP Status—Select to enable/disable the CDP publishing option for the
port.
The next three fields are operational when the switch has been set up
NOTE
to send traps to the management station.
• Syslog Voice VLAN Mismatch—Select to enable the option of sending a
SYSLOG message when a voice VLAN mismatch is detected This means
that the voice VLAN information in the incoming frame does not match what
the local device is advertising.
• Syslog Native VLAN Mismatch—Select to enable the option of sending a
SYSLOG message when a native VLAN mismatch is detected. This means
that the native VLAN information in the incoming frame does not match what
the local device is advertising.
• Syslog Duplex Mismatch—Select to enable the option of sending a
SYSLOG message when duplex information mismatch is detected. This
means that the duplex information in the incoming frame does not match
what the local device is advertising.
Enter the relevant information, and click Apply. The port settings are written to the
Running Configuration.
Administration > Discovery
page.
page.
9
Administration >
139