Cisco 500 series Administration Manual page 282

Configuring IP Information
Management and IP Interfaces
STEP 1
STEP 2
STEP 3
STEP 1
STEP 2
STEP 3
STEP 4
Cisco 500 Series Stackable Managed Switch Administration Guide
To define IPv6 global parameters:
In Layer 2 system mode, click Administration > Management Interface > IPv6
Global Configuration.
In Layer 3 system mode, click IP Configuration > Management and IP Interfaces
> IPv6 Global Configuration.
The IPv6 Global Configuration page opens.
Enter values for the following fields:
• ICMPv6 Rate Limit Interval—Enter how often the ICMP error messages are
generated.
• ICMPv6 Rate Limit Bucket Size—Enter the maximum number of ICMP error
messages that can be sent by the switch per interval.
Click Apply. The IPv6 global parameters are written to the Running Configuration
file.
Defining an IPv6 Interface
An IPv6 interface can be configured on a port, a LAG, VLAN, or ISATAP tunnel
interface. The switch supports one IPv6 interface as an IPv6 end device.
A tunnel interface is configured with an IPv6 address based on the settings
defined in the IPv6 Tunnel page.
To define an IPv6 interface:
In Layer 2 system mode, click Administration > Management Interface > IPv6
Interface.
In Layer 3 system mode, click IP Configuration > Management and IP Interface >
IPv6 Interface.
The IPv6 Interface page opens.
This page displays the IPv6 interfaces already configured.
Click Add to add a new interface on which interface IPv6 is enabled.
The Add IPv6 Interface page opens.
Enter the values.
17
282