Configuring Tcp/Udp Services - Cisco 500 series Administration Manual
Stackable managed switch
Hide thumbs
Also See for 500 series:
- Configuration manual (1140 pages) ,
- Administration manual (653 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Configuring Security
Configuring TCP/UDP Services
STEP 5
Configuring TCP/UDP Services
STEP 1
STEP 2
Cisco 500 Series Stackable Managed Switch Administration Guide
-
Prefix Length—Select the Prefix Length and enter the number of bits that
comprise the source IP address prefix.
Click Apply, and the rule is added to the access profile.
TCP/UDP Services
The
usually for security reasons.
The switch offers the following TCP/UDP services:
•
HTTP—Enabled by factory default
•
HTTPS—Enabled by factory default
•
SNMP—Disabled by factory default
•
Telnet—Disabled by factory default
•
SSH—Disabled by factory default
The active TCP connections are also displayed in this window.
To configure TCP/UDP services:
Click Security > TCP/UDP Services. The TCP/UDP Services page is displayed.
Enable or disable the following TCP/UDP services on the displayed services.
•
HTTP Service—Indicates whether the HTTP service is enabled or disabled.
•
HTTPS Service—Indicates whether the HTTPS service is enabled or
disabled.
•
SNMP Service—Indicates whether the SNMP service is enabled or
disabled.
•
Telnet Service—Indicates whether the Telnet service is enabled or disabled.
•
SSH Service—Indicates whether the SSH server service is enabled or
disabled.
page enables TCP or UDP-based services on the switch,
18
315
Advertisement
Table of Contents
