Cisco 500 series Administration Manual page 218
Stackable managed switch
Hide thumbs
Also See for 500 series:
- Configuration manual (1140 pages) ,
- Administration manual (653 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
VLAN Management
VLAN Groups
STEP 4
STEP 1
STEP 2
STEP 3
STEP 4
Cisco 500 Series Stackable Managed Switch Administration Guide
-
LLC—If this is selected, select the DSAP-SSAP Values.
•
Group ID—Enter a protocol group ID.
Click Apply. The Protocol Group is added, and written to the Running
Configuration file.
Protocol-Based Groups to VLAN Mapping
To map a protocol group to a port, the port must be in General mode and not have
DVA configured on it (see
Several groups can be bound to a single port, with each port being associated to
its own VLAN.
It is possible to map several groups to a single VLAN as well.
To map the protocol port to a VLAN:
Click VLAN Management > VLAN Groups > Protocol-Based Groups to VLAN. The
Protocol-Based Groups to VLAN
The currently-defined mappings are displayed.
To associate an interface with a protocol-based group and VLAN, click Add. The
Add Group to VLAN Mapping page is displayed.
Enter the following fields.
•
Interface—Port or LAG number assigned to VLAN according to protocol-
based group.
•
Group ID—Protocol group ID.
•
VLAN ID—Attaches the interface to a user-defined VLAN ID.
Click Apply. The protocol ports are mapped to VLANs, and written to the Running
Configuration file.
Configuring VLAN Interface
page is displayed.
13
Settings).
218
Advertisement
Table of Contents
