Cisco 500 series Administration Manual page 123

Configuring Discovery
Configuring LLDP
STEP 3
STEP 4
STEP 5
Cisco 500 Series Stackable Managed Switch Administration Guide
To associate additional LLDP MED TLV and/or one or more user-defined LLDP
MED Network Policies to a port, select it, and click Edit. The Edit LLDP MED Port
Settings page opens.
Enter the parameters:
• Interface—Select the interface to configure.
• LLDP MED Status—Enable/disable LLDP MED on this port.
• SNMP Notification—Select whether SNMP notification is sent on a per-port
basis when an end station that supports MED is discovered; for example a
SNMP managing system, when there is a topology change.
• Available Optional TLVs—Select the TLVs that can be published by the
switch by moving them to the Selected Optional TLVs list.
• Available Network Policies—Select the LLDP MED policies to be published
by LLDP by moving them to the Selected Network Policies list. These were
created in the
defined network polices in the advertisement, you must also select
Policy
from the Available Optional TLVs.
The following fields must be entered in hexadecimal characters in the
NOTE
exact data format that is defined in the LLDP-MED standard (ANSI-TIA-
1057_final_for_publication.pdf):
- Location Coordinate—Enter the coordinate location to be published by
LLDP.
- Location Civic Address—Enter the civic address to be published by
LLDP.
- Location (ECS) ELIN—Enter the Emergency Call Service (ECS) ELIN
location to be published by LLDP.
Click Apply. The LLDP MED port settings are written to the Running Configuration
file.
LLDP MED Network Policy page . To include one or more user-
9
Network
123