6.1.2 Removing a High-Speed Network Module
Take the following steps to remove a high‐speed network module.
Although you can remove a high-speed network module while an HN4000 is powered up, any
data traffic or in-band management traffic will be interrupted when the cables are removed from
the module.
Warning
#1 Phillip's screwdriver.
Tools
Step 1. Remove the fiber optic or CAT‐5 network cables from the module's ports.
Step 2. Using the #1 Phillip's head screwdriver, loosen the two mounting screws that secure
Step 3. Grasp the module's two mounting screws and pull out carefully to unseat the module
Step 4. Place the module into an ESD compliant bag.
End of Procedure
920550-5020 Rev 14
the module (Figure 6‐2 on page
from its connector. Then slide the module out of the Universal I/O Slot.
High-Speed Network Modules
6‐2).
HN4000 Hardware Installation Guide
6-3