5.2.1 Connect the HN4000 Switch to the DHCP Network
Step 1. Locate the Ethernet cable that connects to the DHCP server's network and connect it
to the HN4000 switch's 10/100 MGMT port (Figure
Figure 5-2
Connecting Management Port Cable
Step 2. Verify that the 10/100 MGMT port's LINK LED is on. This indicates that the HN4000
has a network connection.
If the 10/100 MGMT port's LINK LED does not come on, verify that the Ethernet cable to the
Note
DHCP network is connected properly and that the network is operating properly
End of Procedure
920550-5020 Rev 14
Loading System Software using DHCP
5‐2).
HN4000 Hardware Installation Guide
5-3