Figure 1-2 Hn4000 Equipment With Hn4Xx-Cp Devices - Hatteras HN4000 Hardware Installation Manual

The HN4000 supports Ethernet‐over‐copper, using 2BASE‐TL on bonded voice‐grade copper
pairs. The HN4000 supports the Hatteras Network's HN4xx‐CP family of CPE devices, which
are designed for installation at customer premises (Figure
the:
❒
HN408‐CP‐1E‐I, HN404‐CP‐1E‐I, and HN402‐CP‐1E‐I— eight‐, four‐, and four‐pair devices
❒ HN408‐U‐2E‐I and HN404‐U‐2E‐I — eight‐ and four‐pair universal devices operating in CP
mode ‐ these devices are available with one or two 10/100 Mbps BASE‐TX network inter‐
faces
❒
HN418‐U‐2E‐I — eight‐pair universal device operating in CP mode ‐ this device is pro‐
vided with one optical 100BASE‐X network interface and one 10/100 Mbps BASE‐TX net‐
work interface
This document uses the term "HN4xx-CP" to refer to Hatteras Networks CP devices or universal
Note
devices operating in CP mode.
Figure 1-2 HN4000 Equipment With HN4xx-CP Devices
920550-5020 Rev 14
HN4000 Metro Ethernet Copper Access Switch Overview
1‐2). The HN4xx‐CP family includes
HN4000 Hardware Installation Guide
1-3