When cabling the HN4000 Stack Ports, you must use the special shielded stacking cables that are
provided by Hatteras Networks. The following cables are available:
•
7 in. (19 cm) — P/N CBL101-0017-42
Caution
•
3 ft. (0.9 m) — P/N CBL101-0003-12
•
10 ft. (3.05 m) — P/N CBL101-0010-12
You can use any combination of the available cables, depending on how the HN4000 switches
are located relative to one another. When connecting HN4000 switches in a stack, the stacking
cables must create a ring. Figure
Device 1
ST ACK PORT S
ST ACK 1
Device 4
ACT IVE
Figure 4-9
Connecting Stacking Cables - Examples
920550-5020 Rev 14
4‐9 shows some examples.
ST ACK 2
ST ACK PORTS
STACK 1
ST ACK 2
Device 4
ACT IVE
Device 2
Device 2
ST ACK PORT S
ST ACK 1
Device 4
STACK 2
ACTIVE
ST ACK PORT S
ST ACK 1
Device 4
ACT IVE
Device 1
Device 2
ST ACK PORT S
ST ACK 1
Device 4
ST ACK 2
ACT IVE
ST ACK PORT S
ST ACK 1
ST ACK 2
Device 4
ACT IVE
Device 4
Device 1
ST ACK PORT S
ST ACK 1
ST ACK 2
Device 4
ACTIVE
Device 3
ST ACK PORT S
ST ACK 1
Device 4
ACT IVE
Cabling 2BASE-TL Ports
STACK 2
Device 3
ST ACK PORT S
ST ACK 1
Device 4
ST ACK 2
ACTIVE
ST ACK PORTS
ST ACK 1
ST ACK 2
Device 4
ACT IVE
Device 5
ST ACK 2
HN4000 Hardware Installation Guide
4-11