1.5
Rack Considerations
HN4000 switches can be mounted in the following rack types with the appropriate mounting
hardware:
❒
19 inch ANSI rack (mounting hardware provided)
❒
23 inch ANSI rack (mounting hardware provided)
❒
600mm ETSI rack (535 mm maximum panel width) (mounting hardware available in
RMK‐02 kit)
1.6
Cabling and Wiring Requirements
Table 1‐5 lists the cables used with the HN4000 equipment. Where a part number is provided,
the cable can be ordered from Hatteras Networks. The intra‐building warning on page
applies to the ports marked with two asterisks (**).
The shielded cables specified in
Caution
Table 1-5
HN4000 Cabling
...
From HN4000
Power port
Ground lug
Dual 100/1000BASE‐T
High‐Speed Ethernet Module**
Dual 100BASE‐X or Dual
1000BASE‐X High‐Speed Ethernet
Module
2BASE‐TL ports
10/100 MGMT port**
Alarm port**
920550-5020 Rev 14
Table 1‐5
To...
Cable Type
Fuse Panel
Power cables (14 ‐ 18 AWG (1.6 ‐ 1.0 mm))
Customer Defined
Ground cable (10 ‐ 14 AWG (2.6 ‐ 1.6 mm))
Customer Defined
CAT‐5e shielded cable
Customer Defined
Fiber optic cable
Customer Defined
25‐pair CAT‐5 24 AWG shielded cable
Customer Defined
CAT‐5e shielded cable
Customer Defined
CAT‐5e shielded cable
must be grounded at both ends.
HN4000 Hardware Installation Guide
Rack Considerations
1‐8
Hatteras Networks
P/N
N/A
N/A
N/A
N/A
CBL100‐0010‐11
10 feet (3.0m)
CBL102‐0025‐12
25 feet (7.6 m)
CBL102‐0050‐12
50 feet (15.2m)
CBL102‐0100‐12
100 feet (30.5m)
N/A
CBL100‐0010‐11
1-7