13
Overview
1.1
General
This document provides the procedures for installing the Hatteras Networks™ HN4000 Metro
Ethernet Copper Access™ switch. There are two switch models in the HN4000 product line —
the HN4000i and the HN4000e (Figure
Figure 1-1
Front View of the HN4000 Switches (HN4000i Top and HN4000e Bottom)
When this document uses the term HN4000, the discussion applies to both switch models — the
Note
HN4000e and the HN4000i.
1.1.1 Objectives
This document is for installation technicians who will install an HN4000 switch at a Central
Office (CO) or at an Outside Plant (OSP) location that has a closed‐loop/filtered cooling system
(such as a Controlled Environment Vault (CEV) or Remote Terminal (RT))
Installation of the HN4000 follows the steps outlined below:
❒
Mount the HN4000 equipment in a rack
❒
Install the power and ground cables
❒
Connect network cables
❒
Turn on power
❒
Verify proper operation of the HN4000
920550-5020 Rev 14
1‐1).
HN4000 Hardware Installation Guide
1