Cabling The 10/100 Management Port; Figure 4-2 10/100Basetx Management Connector - Hatteras HN4000 Hardware Installation Manual

4-2

Cabling the 10/100 Management Port

4.1 Cabling the 10/100 Management Port
Cabling to the 10/100 management port is optional, depending on how the HN4000 will be
managed.
Note
The "10/100 MGMT" port on the HN4000
(DCN). If the customer does not have a DCN then the "10/100 MGMT" port is not cabled.
Static Electricity can damage or decrease the reliability of electrical and optical equipment. While
unpacking and handling electrical and optical equipment, wear a grounding wrist strap to dis-
charge the static buildup. The grounding wrist strap is designed to prevent equipment damage
caused by static electricity. Before unpacking and installing equipment or making system intercon-
nections, connect the grounding wrist strap.
Perform the following steps to connect a CAT‐5 cable to the 10/100 MGMT port.
Step 1. Plug the RJ‐45 connector of the CAT‐5 cable into the HN4000 port labeled "10/100
MGMT" (Figure
Figure 4-2 10/100BaseTX Management Connector
Step 2. Dress the Ethernet cable to the right of the HN4000 and through a cable‐guide slot in
the right‐side mounting bracket.
Step 3. Terminate the other end of the 10/100BaseTX Ethernet Cable per customer require‐
ments.
End of Procedure
HN4000 Hardware Installation Guide
is cabled to a customer Data Communication Network
4‐2).
920550-5020 Rev 14