Cabling The Mlt Ports For Mlt Tests With Third-Party Equipment; Figure 4-13 Connecting Mlt Ports In A Stack For Use With Third-Party Equipment - Hatteras HN4000 Hardware Installation Manual

4-18
Cabling the Metallic Loop Test Access Ports
4.7.2

Cabling the MLT Ports for MLT Tests With Third-Party Equipment

When working with a standalone switch, you can connect a MLT test set (or other test device)
to switch's MLT "IN" port to access the PME that is being tested.
When working with a stack, you can connect the test set to the "OUT" port of the switch on
which the PME under test is located. Or, you can connect the switches' "IN" and "OUT" MLT
ports as shown in the three‐switch example of Figure
the test‐set plug as you test PMEs on different switches.

Figure 4-13 Connecting MLT Ports in a Stack for use with Third-Party Equipment

HN4000 Hardware Installation Guide
4‐13 so that you do not have to relocate
920550-5020 Rev 14