4.2.2 Cabling a Dual 100/1000BASE-T High-Speed Network Module
Perform the following steps to connect Ethernet cables to Port 1 and 2 of a 100/1000BASE‐T
high‐speed network module (HN4000‐GbT). The cables must be Ethernet CAT‐5e (or better).
Step 1. Verify that the Ethernet cables are long enough to maintain a proper bending radius
where the cables enter the front of the HN4000 and are routed through a cable‐guide
slot in the right‐side mounting bracket.
Step 2. Connect a cable to Port 1 and (optionally) to Port 2 of the high‐speed module.
Step 3. Dress the cables to the right of the HN4000 and through a cable‐guide slot in the
right‐side mounting bracket.
Step 4. Terminate the other end of the Ethernet cables per customer requirements.
End of Procedure
4.2.3 Cabling a Dual T3/E3 High-Speed Network Module
Perform the following steps to connect cables to the TX and RX ports of an Unchannelized
T3/E3‐TX module (HN4000‐TE3).
The T3/E3‐TX module is provided with two 10" (254 mm) mini‐BNC to BNC adapter cables.
Figure
4‐3 shows an adapter cable.
Figure 4‐4 Mini‐BNC to BNC Adapter Cable for T3/E3‐TX Module
920550-5020 Rev 14
Cabling a High-Speed Network Module
BNC Connector
Mini-BNC Connector
HN4000 Hardware Installation Guide
4-5