Checking And Maintenance; Preventive Maintenance With Automated Service Message; Resetting The Automatic Maintenance Message; Caution - REMEHA CALORA TOWER GAS 15S EX Installation And Service Manual

CALORA TOWER GAS 15S EX CALORA TOWER GAS 25S EX
CALORA TOWER GAS 35S EX
8

Checking and maintenance

8.1

Preventive maintenance with automated service message

1x
22/04/2016 - 300026141-001-07
When it is time to carry out maintenance on the boiler, the following
instructions are shown on the display:
In a yellow display:
4 The symbol ?
4 The symbol K
4 Maintenance message Z, B or c
Thanks to the automatically transmitted maintenance message, it is
possible to carry out preventive maintenance and therefore use the
maintenance kits defined by Remeha, thus reducing breakdowns to
a minimum. The maintenance message indicates which kit should be
used. These maintenance kits (A, B or C) are available from your
spare parts supplier. If no other faults are noted during the inspection
initiated subsequent to the maintenance message, these
maintenance kits include all of the parts needed for the maintenance
concerned (such as the gaskets, for example).
8.1.1.
A service message on the boiler display must be reset by a qualified
installer after the maintenance service has been carried out using the
relevant service set. To do this, proceed as follows:
1. When the maintenance message is displayed, press key J 1
2. Use keys [-] or [+] to input the installer code 0012 .
3. Confirm using key S . The maintenance message is reset. The
T001629-A
When a maintenance message is displayed, it must
4
be acted upon within the 2 months following the
appearance of the message.

CAUTION

Reset the maintenance message to zero after each
inspection.
Resetting the automatic maintenance
message
time. c0de appears on the display.
display returns to the current operating mode.
8. Checking and maintenance
77