DAELIM Roadwin R Service Manual page 171

GEAR CHANGE SWITCH GEAR CHANGE SWITCH GEAR CHANGE SWITCH GEAR CHANGE SWITCH GEAR CHANGE SWITCH
GEAR CHANGE SWITCH GEAR CHANGE SWITCH GEAR CHANGE SWITCH GEAR CHANGE SWITCH GEAR CHANGE SWITCH GEAR CHANGE SWITCH
GEAR CHANGE SWITCH GEAR CHANGE SWITCH
GEAR CHANGE SWITCH GEAR CHANGE SWITCH GEAR CHANGE SWITCH GEAR CHANGE SWITCH GEAR CHANGE SWITCH
PIN PIN PIN PIN PIN
PIN PIN PIN PIN PIN PIN
PIN PIN
PIN PIN PIN PIN PIN
CRANKCASE/TRANSMISSION/CRANKSHAFT
Make sure that there is no gap between the
mating surfaces of the right and left crankcase.
Tighten the left crankcase bolts in a crisscross
pattern in 2-3 steps.
TORQUE : 1.1kgf m(11N m)
Tighten the right crankcase bolt to the specified
torque.
TORQUE : 1.1kgf m(11N m)
After replacing the o-ring of the gear change
switch to a new one, coat the new o-ring with
engine oil, then install the switch pin into the
groove of the shift drum.
12-11