Battery Removal/Installation; Battery Voltage Inspection; Battery Charging - DAELIM Roadwin R Service Manual

TERMINAL TERMINAL TERMINAL TERMINAL TERMINAL
TERMINAL TERMINAL TERMINAL TERMINAL TERMINAL TERMINAL
TERMINAL TERMINAL
TERMINAL TERMINAL TERMINAL TERMINAL TERMINAL
TERMINAL TERMINAL TERMINAL TERMINAL TERMINAL
TERMINAL TERMINAL TERMINAL TERMINAL TERMINAL TERMINAL
TERMINAL TERMINAL TERMINAL TERMINAL
TERMINAL TERMINAL TERMINAL
BATTERY HOLDER BATTERY HOLDER BATTERY HOLDER
BATTERY HOLDER BATTERY HOLDER BATTERY HOLDER BATTERY HOLDER
BATTERY HOLDER BATTERY HOLDER BATTERY HOLDER BATTERY HOLDER BATTERY HOLDER BATTERY HOLDER
BATTERY HOLDER BATTERY HOLDER BATTERY HOLDER BATTERY HOLDER BATTERY HOLDER
BATTERY/CHARGING SYSTEM
BATTERY
REMOVAL/INSTALLATION
Remove the seat. ( 13-2)
Remove the battery band.
Disconnect the negative cable and then the positive
cable and remove the battery.
Install the battery in the reverse order of removal with
the proper wiring.
Always turn the ignition switch to "OFF" before
removing the battery.
Connect the positive terminal first and then the
negative cable.
VOLTAGE INSPECTION
Measure the battery voltage using a multi tester.
VOLTAGE:
- Fully charged : 13.0~13.2V
- Under charged : Below 12.3V
TOOL : MULTI-TESTER
Use a voltmeter that will accurately indicate 0.1V
difference.
Never open the sealed filler cap.
When measuring the battery voltage after
charging, leave it for at least 30 minutes, or the
accurate results cannot be obtained because the
battery voltage fluctuates just after charging.

BATTERY CHARGING

Remove the battery.
Connect the charger positive (+) cable to the battery
positive (+) terminal.
Connect the charger negative(-) cable to the battery
negative(-) terminal.
Quick-charging should only be done in an
emergency ; slow charging is preferred.
For battery charging ; do not exceed the charging
current and time specified on the battery. Using
excessive current or extending the charging time
may damage the battery.
17-3